Acrylic products need to be bonded in the process of production, in order to ensure that the product is spliced
Do not produce bubbles, what effective measures should we take? Next PG Xiaobian to give you specific
Let me introduce you.
1, adhesive erosion acrylic products will leave difficult to remove
Therefore, in order to protect the parts that do not need to be glued, self-adhesive adhesive can be affixed and acrylic products can be glued.
2, the adhesive will be hindered by grease, dust or bubble holes and leave bubbles, you can use the method of cleaning
Remove surface bubbles.
3, the use of too little adhesive will make the adhesive surface of acrylic products can not be fully coated, or the adhesive is curing
When contracting, part of the air is brought in to produce bubbles, so we need to pay attention to the amount of adhesive and curing time.
4, direct blowing will make the edge of the adhesive section white due to the rapid volatilization of the adhesive, which will also produce gas
Bubble, so we must look at the surrounding environment when bonding.
5, the surface stress and the surface stress and degradation caused by the cutting tool, if there is no place
When the line is directly bonded, it will produce bubbles, and we must pay attention to this.
The above is about the solution of acrylic products splicing bubbles, I hope to help you
Help. For more information about acrylic products and acrylic sheets, pay attention to PG.
https://www.pgacrylic.com
