Injection molding is carried out by using pellets obtained by suspension polymerization as raw materials and molding on a conventional plunger type or screw type injection molding machine. It should be noted that due to the poor fluidity of the acrylic particles, the flow resistance of the injection...
The treatment of the crack at the bottom corner of the mold after pressing the acrylic base plate is as follows: 1. The bottom plate pressing is the best starting time controlled in about 2 minutes. 2. The four corners of the bottom plate of the bottom plate should be smooth and inclined. The method...
Buying materials is most afraid of buying plates without quality assurance. After all, a plate is not cheap. Take the acrylic plate as an example. The board can vary from a few hundred to a thousand. How to buy a safe board, the following suggestions are for reference: 1.transparency identification ...
Acrylic uv printers are widely used in various signage, field light box advertisements, badges, display cards, etc. Acrylic is an important plastic polymer material with good transparency, chemical stability and weather resistance, and the appearance is smooth and textured. Strong, high-grade, color...
The bonding of acrylic sheets is a very important part in the processing of acrylic products. How to show the clear and transparent characteristics of acrylic, reflect the value of acrylic crafts, maximize the grade and taste of acrylic crafts, bonding technology plays a decisive role here. The bond...
1.docking Place two acrylic sheets to be docked horizontally on the operating platform, close them, and stick a tape on the bottom to leave a gap of no more than 0.3mm to prepare the adhesive. Use a syringe to inject the Kelly adhesive from the side evenly and slowly from the gap until it is fully f...
https://www.pgacrylic.com/